Kirobrasal

EN 1045 FL10

Description

Corrosive and hygroscopic flux powder to braze aluminium and its alloys with our Al Si 12 alloy (AA 4047). Useful for induction brazing and for flame brazing. Excellent capillarity.

Application

For best results the flux should be mixed with water and stirred to a creamy consistency. Heat until flux becomes liquid. After brazing it is necessary to clean and to wash the surface from the flux residual.

Kirobrasal Neutro

EN 1045 FL20

Description

Non corrosive and non hygroscopic flux powder to braze aluminium and its alloys with our Al Si 12alloy (AA 4047). Excellent for furnace brazing in a inert atmosphere with aluminium alloys with Mg < 0.4-0.5%, for induction brazing and also for flame brazing aluminium alloys up to 1.5% Mg content.

Application

For furnace brazing can be applied like an aqueous slurry by flooding, spraying or dipping; the part must be dried before enter in the furnace. For best results with induction and flame brazing, the flux should be mixed with water and stirred to a creamy consistency. Heat until flux becomes liquid. No post brazing treatment are required.

Flux 600 MG

EN 1045 FH10

Description

Flux powder, available also in paste, for brazing brass, bronze, steel and stainless steel with high silver content alloys. FLUX 600 MG is also used to braze copper and brass with copper phosphorus alloys.

Application

Suitable to braze in furnace or with torch flame. For best results flux should be mixed with water and stirred to a creamy consistency. Heat until flux becomes liquid. Flux residue may be removed with warm water.

Flux 650

EN 1045 FH10

Description

FLUX 650 is a flux powder for brazing brass, bronze, steel and stainless steel with high silver content alloys. FLUX 650 is also used for copper-brass brazing with copper phosphorus alloys.

Application

The flux is suitable to use for torch brazing. It’s suitable to use it in powder on deeping the heatedrod into the flux. At the end clean the surface with warm water.

Flux 700

EN 1045 FH12

Description

A flux powder, available also in paste, for brazing brass, bronze, steel with medium silver contentalloys.

Application

Suitable for induction brazing or for flame brazing. For best results flux should be mixed with water and prepared as a paste. Heat until flux becomes liquid. Flux residue may be removed with warm water.

Flux 700 AD

EN 1045 FH12

Description

A flux powder for brazing brass, bronze, steel with medium silver content alloys.

Application

Suitable for induction brazing or for flame brazing. For best results flux should be mixed with water and, thanks the special composition, it’s easy to get a creamy consistency of the paste. Heat until flux becomes liquid. Flux residue may be removed with warm water.